Products

Antimicrobial Cavity Cleanser

DESCRIPTION:

FiteBac® Antimicrobial
Cavity Cleanser

2% K21 QAS aqueous ethanolic solution

DOWNLOAD PDF FILES:

IFU FILE
SDS FILE
FDA 510K

INDICATIONS FOR USE

Intended for cleansing and moistening/re-wetting of cavity preparations

TARGET AUDIENCE:

Prescription use for Dental Professionals

DEVELOPMENT STATUS:

Cleared for Marketing in the United States

PLANNED COMMERCIAL INTRODUCTION:

Available

BENEFITS:

Remove debris in carious lesion preparations and can penetrate exposed dentin tubules allowing restorative adhesives to tightly bind to the prepared dentin surface while also addressing residual microbial contamination within the restoration site.

1. The dentist isolates the tooth with a rubber dam and clamp.
2. Inspect all crevices and groove areas for accessing decay.
3. Remove all visible decay, then apply caries indicator (Sable Seek by Ultradent Products) for 10 seconds to the rinsed and dried dentin.
4. Rinse and dry the cavity preparation and remove any visible stain or carious areas.
5. Rinse, dry, and inspect the cavity preparation once more prior to etchant.
6. Etch the preparation with 37% phosphoric acid on enamel margins and all dentin surfaces for 15 seconds using the total-etch technique.
7. Thoroughly rinse the cavity preparation with air and water for 15 seconds.
8. Then dry the cavity, leaving dentin surfaces slightly moist—dry but not desiccated.
9. Generously apply FiteBac with a microbrush onto dentin surfaces with slight rubbing action for 20 seconds.
10. Any pooling of FiteBac can be removed with cotton pellets and then gently air-dried, leaving a moist-looking surface.
11. Apply universal bond with a microbrush to dentin for 20 seconds with rubbing action that’s allowed to wet the etched enamel. Then gently air-dry the preparation for 5 seconds and vigorously dry it using air only for an additional 10 to 15 seconds.
12. Expose the preparation to a VALO™ curing light from Ultradent Products for 10 seconds on high-power mode.
13. Apply G-aenial™ Universal Injectable from GC America to dentin floor and manipulate it up to the enamel margins with explorer or probe to coat all dentin walls.
14. Apply, contour and sufficiently cure the final layers of A1 or B1 composite.
15. Finally, polish the restoration with carbide burs, remove the flash with a scaler prior to rubber dam removal and bite adjustment.